44re transmission band adjustment Loosen band adjusting screw locknut. Dodge / Chrysler Rear Wheel Drive Band Adjustment Settings. I got a couple of responses and thank those gentlemen. Then back locknut off 3-5 turns. Aug 31, 2013 · Has anyone here done a front and/or read band adjustment on a 44RE? I have a '98 Jeep Grand Cherokee that I'm going to drop the pan on, and after 150k, I think it would be a good time to adjust the band(s). Oct 13, 2006 · Last week I asked for some guidance on the correct transmission band adjustment on my 1994 GC 42RE transmission. 150k miles and higher replace governor stuff and adjust bands. Hold the throttle open for the outside band, remove the pan for the inside band. A904 / A727 / A500 / A518 / A618 / TF6 / TF8 / 42RH42RE / 44RE / 46RH / 46RE / 47RH / 47RE / 48RET Jul 18, 2024 · - TLDR: adjust both transmission bands while replacing governor solenoid and pressure sensor. 42/44RE (A500) 4-SPEED FRONT BAND ADJUSTMENT The front (kickdown) band adjusting screw is located on the left side of the transmission case above the manual valve and throttle valve levers. Jul 5, 2005 · From Bill Konolday's 47RE notes: I usually go a little looser than factory specs on this front band - backing off the adjustment screw 2 or 2 1/4 turns. Depending on the circumstances I have backed off the band up to 2 1/2 turns. Front Band Adjustemnt Screw Location 2. Raise vehicle. You also have to remove the Transmission filter so this is a good time to throw a new filter on (filter is held on with 2 small torx bit screws). . Apr 10, 2009 · The rear band was much easier, you have to remove the transmission pan and drain the fluid for this one as it is located on the valve body. It looks like the "book" adjustment is is 3 5/8 for the front and 4 for the rear. 1. zstk tpn rhnh pbmle ymdo kaadh awd najfb tqps btza